4. SYSTEM MODE (For Service Persons and System Administrators) EO13-33005
4.3 Mode Setting (Printer Operation Mode)
4- 25
4.3.6 Print Type Setting (PRINT TYPE)
This setting is issue mode setting.
Notes:
1. When the [FEED] key is pressed, the menu moves in the opposite direction from when the [PAUSE] key
is pressed.
2. When the [FEED] and [PAUSE] keys are simultaneously pressed, the display returns to the system
mode menu.
3. When the [FEED] key or [PAUSE] key is pressed for 0.5 seconds or more during this parameter setting,
repeat mode is enabled and the key pressed is repeatedly entered.
4. The change in the parameter setting becomes effective when the [POWER] key is pressed after setting,
then stored in the backup memory.
PRINT TYPE AUTO
Print depending on the sensor used
(Automatic selection from Batch or STRIP) (Factory default)
[PAUSE]
PRINT TYPE BATCH
Fixed to batch issue
[PAUSE]
PRINT TYPE STRIP Fixed to strip issue
[PAUSE]
To Next Page
Loading...
Need help?
General