4. SYSTEM MODE (For Service Persons and System Administrators) EO13-33005
4.3 Mode Setting (Printer Operation Mode)
4- 24
4.3.4 B-SP Series Compatibility Mode Setting (B-SP MODE)
This setting enables the use of software assets created during the development of the B-SP series.
Notes:
1. When the [FEED] key is pressed, the menu moves in the opposite direction from when the [PAUSE] key
is pressed.
2. When the [FEED] and [PAUSE] keys are simultaneously pressed, the display returns to the system
mode menu.
3. When the [FEED] key or [PAUSE] key is pressed for 0.5 seconds or more during this parameter setting,
repeat mode is enabled and the key pressed is repeatedly entered.
4. The change in the parameter setting becomes effective when the [POWER] key is pressed after setting,
then stored in the backup memory.
5. This setting allows the use of software assets of the B-SP series as they are, but the area where the
mechanism is different cannot be used (no compatibility).
4.3.5 Linerless Setting (LINERLESS)
This setting is for using a linerless label.
Notes:
1. When the [FEED] key is pressed, the menu moves in the opposite direction from when the [PAUSE] key
is pressed.
2. When the [FEED] and [PAUSE] keys are simultaneously pressed, the display returns to the system
mode menu.
3. When the [FEED] key or [PAUSE] key is pressed for 0.5 seconds or more during this parameter setting,
repeat mode is enabled and the key pressed is repeatedly entered.
4. The change in the parameter setting becomes effective when the [POWER] key is pressed after setting,
then stored in the backup memory.
B-SP MODE OFF B-SP series compatibility mode is disabled. (Factory default)
[PAUSE]
B-SP MODE ON B-SP series compatibility mode is enabled.
[PAUSE]
LINERLESS OFF Linerless setting is disabled. (Factory default)
[PAUSE]
LINERLESS ON Linerless setting is enabled.
[PAUSE]
To Next Page
Loading...
Need help?
General