4. SYSTEM MODE (For Service Persons and System Administrators) EO13-33005
4.5 Printer Parameter Fine Adjustment
4- 43
4.5.2 Feed Amount Fine Adjustment (FEED ADJ.)
This parameter is to fine adjust a feed amount after printing (= to fine adjust the next media’s print start
position).
Use the [PAUSE] key to select a desired option. (Range: -50.0mm to +50.0mm)
• Feed Amount Fine Adjustment (Example)
Notes:
1. When the [FEED] key is pressed, the menu moves in the opposite direction from when the [PAUSE] key is
pressed.
2. When the [PAUSE] key is pressed while the [FEED] key is held down, or when the [POWER] key is pressed
for 3 seconds or more, the display returns to the system mode menu (ADJUST SET).
3. When the [PAUSE] key or [FEED] key is pressed for 0.5 seconds or more during this fine adjustment
setting, repeat mode is enabled and the key pressed is repeatedly entered.
4. The change in the fine adjustment value becomes effective when the [POWER] key is pressed after setting,
then stored in the backup memory.
5. The printer is controlled by the total amount determined by this command and the Position Fine Adjustment
command sent from the PC. However, the maximum value is ±50.0 mm.
6. When the feed amount fine adjustment value for the positive (+) direction is set to more than +10.5 mm (the
distance between the print head and the sensor is –1 mm), the actual print position is corrected by +10.5
mm.
7. The factory default value is +0.0mm.
[PAUSE]
FEED ADJ.+50.0mm
FEED ADJ.+49.9mm
FEED ADJ.+0.0mm
FEED ADJ.-49.9mm
FEED ADJ.-50.0mm
FEED ADJ.+0.1mm
FEED ADJ.-0.1mm
[FEED]
To Next Page
Loading...
Need help?
General