Toshiba B-EP2DL Series - Strip Position Fine Adjustment (PEEL ADJ.)

4. SYSTEM MODE (For Service Persons and System Administrators) EO13-33005
4.5 Printer Parameter Fine Adjustment
4- 48
4.5.7 Strip Position Fine Adjustment (PEEL ADJ.)
This parameter is to fine adjust a strip position.
Use the [PAUSE] key to select a desired option. (Range: -2.0mm to +3.0mm)
• Strip Position Fine Adjustment (Example)
[FEED]
[PAUSE]
PEEL ADJ.-2.0mm
PEEL ADJ.-1.9mm
CUT ADJ.+0.0mm
CUT ADJ.+2.9mm
CUT ADJ.+3.0mm
CUT ADJ.-0.1mm
CUT ADJ.+0.1mm
+0.0 mm
+3.0 mm
-2.0 mm
Strip stop position (top edge of strip shaft)
Strip stop position (top edge of strip shaft)
Strip stop position (top edge of strip shaft)
Paper feed direction