4. SYSTEM MODE (For Service Persons and System Administrators) EO13-33005
4.10 BASIC Setting
4- 112
Note:
When the BASIC setting is ON, the issue mode automatically changes to TPCL mode, and afterwards, the
issue mode does not change even when the BASIC setting is set to OFF.
To select other mode, change the mode following the Mode setting procedure.
4.10.2 BASIC Interpreter Setting (BASIC ENABLE)
Notes:
1. When the [FEED] key is pressed, the menu moves in the opposite direction from when the [PAUSE]
key is pressed.
2. When the [FEED] and [PAUSE] keys are simultaneously pressed, the display returns to the System
mode menu.
3. When the [FEED] key or [PAUSE] key is pressed for 0.5 seconds or more during this setting, repeat
mode is enabled and the key pressed is repeatedly entered.
4. The change in the parameter setting becomes effective when the [POWER] key is pressed after
setting, then stored in the backup memory.
BASIC OFF
Disabled (Factory default)
[PAUSE]
BASIC ON
Enabled
[PAUSE]
To Next Page
Loading...
Need help?
General