4. SYSTEM MODE (For Service Persons and System Administrators) EO13-33005
4.4 Parametr Setting
4- 35
4.4.10 Power Save Mode Timing Setting (SLEEP)
This setting selects a time for the printer to enter power save mode. When the printer enters power save
mode, the sleep mark
on the LCD turns on. (Factory default is 3 sec.)
Notes:
1. When the [FEED] key is pressed, the menu moves in the opposite direction from when the [PAUSE] key
is pressed.
2. When the [FEED] and [PAUSE] keys are simultaneously pressed, the display returns to the system
mode menu.
3. When the [FEED] key or [PAUSE] key is pressed for 0.5 seconds or more during this parameter setting,
repeat mode is enabled and the key pressed is repeatedly entered.
4. The change in the parameter setting becomes effective when the [POWER] key is pressed after setting,
then stored in the backup memory.
SLEEP 1sec
[PAUSE]
SLEEP 2sec
[PAUSE]
It takes a shorter time to enter power save mode.
SLEEP 3sec
[PAUSE]
SLEEP 28sec
[PAUSE]
SLEEP 29min
[PAUSE]
SLEEP 30min
[PAUSE]
It takes a longer time to enter power save mode.
To Next Page
Loading...
Need help?
General