4. SYSTEM MODE (For Service Persons and System Administrators) EO13-33005
4.10 BASIC Setting
4- 111
4.10 BASIC Setting
The Basic function enables the printer to operate with the program created for other printers, by converting
it to Basic program and downloading this Basic program to the printer. Setting the downloaded Basic
program to be enabled/disabled, browsing the program file, data file, and area file, etc. are available in this
mode. For details, refer to the Basic Interpreter Specification and the Specification of Program Loader for
Basic Interpreter.
4.10.1 BASIC Setting Operation Example
This setting is BASIC Function.
System mode menu display (BASIC setting)
[FEED]
<9>BASIC SETTING
<0>SHUTDOWN
System mode menu display (Shutdown)
BASIC ENABLE
BASIC interpreter setting
[POWER]
BASIC OFF
BASIC setting display
FILE MAINTENANCE
BASIC file browser setting
[POWER]
0 0 - - - - - - -
BASIC TRACE
Power OFF
[FEED] and [POWER]
While holding down the [FEED] key, press the [POWER] key to turn the power
[POWER]
[POWER]
[POWER]
TRACE OFF
[POWER]
EXPAND MODE
[POWER]
The name of the file stored is displayed.
BASIC trace setting
BASIC trace setting display (Mode setting)
[POWER]
<9>BASIC SETTING
BASIC expansion mode
System mode menu display (BASIC setting)
[POWER]
<0>SHUTDOWN
System mode menu display (Shutdown)
Hold down the [POWER] key for 3 seconds or more.
[POWER]
Power OFF
Press the [POWER] key.
The setting is updated at shutdown.
To Next Page
Loading...
Need help?
General