4. SYSTEM MODE (For Service Persons and System Administrators) EO13-33005
4.9 Interface Setting
4- 83
4.9.3 USB Serial Number Setting
This mode is setting the USB serial number.
Notes:
1. Characters that can be used for setting: Space, 0 to 9, A to Z
2. When the [FEED] key is pressed, the menu moves in the opposite direction from when the [PAUSE]
key is pressed.
3. When the [FEED] and [PAUSE] keys are simultaneously pressed, the display returns to the system
mode menu.
4. When the [FEED] key or [PAUSE] key is pressed for 0.5 seconds or more during this setting, repeat
mode is enabled and the key pressed is repeatedly entered.
5. The change in the parameter setting becomes effective when the [POWER] key is pressed after
setting, then stored in the backup memory.
SERIAL NUMBER
USB serial number setting
[POWER]
Setting of 1st digit (Refer to Note 1)
[POWER]
Press the [PAUSE] or [FEED] key to set the value.
Press the [POWER] key to determine the value.
(Moves to the next digit.)
[PAUSE] or [FEED]
Setting of 2nd digit (Refer to Note 1)
[POWER]
Press the [PAUSE] or [FEED] key to set the value.
Press the [POWER] key to determine the value.
(Moves to the next digit.)
[PAUSE] or [FEED]
Repeat
Setting of 11th digit (Refer to Note 1)
[POWER]
[PAUSE] or [FEED]
Press the [PAUSE] or [FEED] key to set the value.
Press the [POWER] key to determine the value.
(Moves to the next digit.)
Setting of 12th digit (Refer to Note 1)
[POWER]
[PAUSE] or [FEED]
<8>I/F SETTING
Press the [PAUSE] or [FEED] key to set the value.
Press the [POWER] key to determine the value.
System Mode menu display. (Interface Setting)
To Next Page
Loading...
Need help?
General