4. SYSTEM MODE (For Service Persons and System Administrators) EO13-33005
4.6 Test Print
4- 55
4.6.3 Test Print Condition Setting (PRINT CONDITION)
The print conditions for the Test Print should be specified before printing.
Notes:
1. When the [FEED] key is pressed, the menu moves in the opposite direction from when the [PAUSE]
key is pressed.
2. When the [FEED] and [PAUSE] keys are simultaneously pressed, the display returns to the system
mode menu.
3. When the [FEED] key or [PAUSE] key is pressed for 0.5 seconds or more during this setting, repeat
mode is enabled and the key pressed is repeatedly entered.
4. The change in the parameter setting becomes effective when the [POWER] key is pressed after
setting, then stored in the backup memory.
5. The default value at power on is PRINT CONDITION (test print condition parameter setting).
Test print condition parameter setting mode
Issue count setting
Label length setting
Paper feed mode
PRINT CONDITION
ISSUE COUNT 1
TYPE AUTO
LABEL LEN. 63mm
PAPER NO FEED
[POWER]
[POWER]
[POWER]
[POWER]
<5>TEST PRINT
Character print
[POWER]
Print type setting (BATCH/STRIP)
SENSOR NONE
[POWER]
[POWER]
SLANT LINE(1DOT)
1-dot slant line print mode
Moves to the test print mode selected.
System mode menu display (Test Print)
To Next Page
Loading...
Need help?
General