4. SYSTEM MODE (For Service Persons and System Administrators) EO13-33005
4.9 Interface Setting
4- 93
(6) Socket Communication Setting (SOCKET PORT)
This setting is socket port.
Operation when socket communication is set to ON.
Notes:
1. Factory default is “ON (08000)”.
2.
The value to be entered is limited depending on the number entered in each digit because the printer ID
range is 00000 to 65535.
For example:
If 1st digit=6, 2nd digit must be 1 to 5.
If 1st digit=6 and 2nd digit=5, 3rd digit must be 1 to 5.
If 1st digit=6, 2nd digit=5, and 3rd digit=5, 4th digit must be 1 to 3.
If 1st digit=6, 2nd digit=5, 3rd digit=5, and 4th digit=3, 5th digit must be 1 to 5.
SOCKET PORT
PORT OFF - - - - -
Socket port setting
[POWER]
Socket port communication setting OFF.
[PAUSE]
PORT ON 0 8 0 0 0
Socket port communication setting ON
[PAUSE]
PORT ON 0 8 0 0 0
PORT ON 0 8 0 0 0
Setting of 1 s t digit (Range: 0 to 6) (Refer to Note 2)
0
[POWER]
Press the [PAUSE] or [FEED] key to set the value.
Press the [POWER] key to determine the value.
(Moves to the next digit.)
[PAUSE] or [FEED]
Setting of 2nd digit (Refer to Note 2)
8
PORT ON 0 8 0 0 0
[POWER]
Press the [PAUSE] or [FEED] key to set the value.
Press the [POWER] key to determine the value.
(Moves to the next digit.)
[PAUSE] or [FEED]
Setting of 3rd digit (Refer to Note 2)
0
PORT ON 0 8 0 0 0
[POWER]
Press the [PAUSE] or [FEED] key to set the value.
Press the [POWER] key to determine the value.
(Moves to the next digit.)
[PAUSE] or [FEED]
Setting of 4th digit (Refer to Note 2)
0
PORT ON 0 8 0 0 0
[POWER]
Press the [PAUSE] or [FEED] key to set the value.
Press the [POWER] key to determine the value.
(Moves to the next digit.)
[PAUSE] or [FEED]
Setting of 5th digit (Refer to Note 2)
0
[POWER]
Press the [PAUSE] or [FEED] key to set the value.
Press the [POWER] key to determine the value.
[PAUSE] or [FEED]
DHCP
System mode menu display (Interface setting)
To Next Page
Loading...
Need help?
General