Toshiba B-FV4 Series User Manual

8. UPDATING FIRMWARE EO18-33030
8.3 Updating Firmware in Atmel Mode
8-15
13. Turn off your printer.
14. Set DIP Switch 1 and 2 to the ON position (up). If it’s inconvenient to set DIP Switch while
cables are connected, unplug all the cables to do this.
15. Reinstall the base and the secure it with four screws.
16. Turn over your printer.
17. Turn on your printer.

Toshiba B-FV4 Series Specifications

General

Resolution	203 dpi
Print Method	Thermal Transfer / Direct Thermal
2D Codes	Data Matrix, PDF417, QR Code, Maxi Code
Operating Temperature	5 – 40 °C
Storage Temperature	-20 – 60 °C
Power Supply	100-240 VAC, 50/60 Hz
Interfaces	USB, Serial (RS-232)
Media Width	25.4 – 112 mm