Toyota 2002 Camry - Page 1075

B56306
Driving Axis
Clockwise
Counterclockwise
70–4
–WINDSHIELD/WINDOWGLASS/MIRROR POWER WINDOW CONTROL SYSTEM
2537Author: Date:
(1) Set the DC 400 A probe to terminal 4 or 5 of the wire harness.
NOTICE:
Match the arrow mark of the probe with the current direction.
(2) Set the door glass at the fully closed position.
(3) When approximately 60 seconds have passed after fully closing the door glass, check how long
the current when pressing the power regulator switch UP again (at initial time) takes to change
from approximately 16 – 34 A to less than 1 A.
Standard: Approximately 4 – 90 seconds
(4) When approximately 60 seconds have passed after the cutoff checking, check that the door
glass will go down when the power regulator switch is pressed DOWN.
5. INSPECT POWER WINDOW REGULATOR MOTOR
ASSY LH
(a) Inspect the operation of the rear LH side power window
regulator motor assembly.
(1) When adding the battery voltage to each connector
terminal, check that the motor operates smoothly.
Standard:
Measuring condition Operational direction
Battery positive – Terminal 5
Battery negative – Terminal 4
Clockwise rotation toward driving axis
Battery positive – Terminal 4
Battery negative – Terminal 5
Counterclockwise wind rotation toward
driving axis
(b) Check the PTC operation inside the power window regulator motor.
NOTICE:
Work must be perform with the power window regulator and door glass installed to the vehicle.
(1) Set the DC 400 A probe terminal 4 or 5 of the wire harness.
NOTICE:
Match the arrow mark of the probe with the current direction.
(2) Set the door glass at the fully closed position.
(3) When approximately 60 seconds have passed after fully closing the door glass, check how long
the current when pressing the power regulator switch UP again (at initial time) takes to change
from approximately 16 – 34 A to less than 1 A.
Standard: Approximately 4 – 90 seconds
(4) When approximately 60 seconds have passed after the cutoff checking, check that the door
glass will go down when the power regulator switch is pressed DOWN.