Toyota 2002 Camry - Remove Crankshaft; Inspect Cylinder Block for Flatness

10
A36646
A36648
14–122
–ENGINE MECHANICAL CYLINDER BLOCK (2AZ–FE)
1646Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
9. REMOVE CRANKSHAFT
(a) Uniformly loosen and remove the 10 bearing cap sub–as-
sembly bolts, in several passes, in the sequence shown.
(b) Remove the bearing cap and crankshaft.
10. REMOVE CRANKSHAFT THRUST WASHER UPPER
11. REMOVE CRANKSHAFT BEARING
NOTICE:
Arrange the bearings in the correct order.
12. REMOVE CRANKSHAFT BEARING NO.2
NOTICE:
Arrange the main bearings and thrust washers in the correct order.
13. REMOVE STUD BOLT
14. INSPECT CYLINDER BLOCK FOR FLATNESS
(a) Using a precision straight edge and feeler gauge, mea-
sure the surface contacting the cylinder head gasket for
warpage.
Maximum warpage: 0.05 mm (0.0020 in.)