320D3–01
–BRAKE REAR DISC BRAKE
32–33
2021Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
OVERHAUL
HINT:
COMPONENTS: See page 32–31
Overhaul the RH side by the same procedures with LH side.
Two types of brake pad exist; one is with slit and the other without slit.
1. REMOVE REAR WHEEL
2. DRAIN BRAKE FLUID
NOTICE:
Wash off the brake fluid immediately if it comes into contact with a painted surface.
3. DISCONNECT REAR LH FLEXIBLE HOSE
(a) Remove the union bolt and a gasket from the disc brake cylinder, then disconnect the flexible hose
from the disc brake cylinder.
HINT:
Gasket has 2 types: 2–piece type and 1–piece type.
4. REMOVE REAR DISC BRAKE CYLINDER SLIDE PIN
(a) TMC made:
Remove the cylinder slide pin.
(b) TMMK made:
Remove the cylinder slide pin and cylinder slide bush.
5. REMOVE DISC BRAKE CYLINDER ASSY RR LH
(a) TMC made:
Lift up the disc brake cylinder and remove the disc brake cylinder.
(b) TMMK made:
Remove the cylinder slide pin and disc brake cylinder.
6. REMOVE DISC BRAKE PAD KIT REAR (PAD ONLY)
(a) Remove the 2 brake pads with the anti–squeal shim.
7. REMOVE REAR DISC BRAKE ANTI SQUEAL SHIM KIT
(a) Remove the 2 anti–squeal shims and pad wear indicator from each of 2 brake pads.
(b) TMC made:
Remove the 2 pad wear indicator plates from each of 2 brake pads.
(c) TMMK made:
Remove the pad wear indicator plate from inner pad.
8. REMOVE REAR DISC BRAKE PAD SUPPORT PLATE
(a) Remove the rear disc brake pad support plate No.1.
9. REMOVE REAR DISC BRAKE PAD SUPPORT PLATE
(a) Remove the rear disc brake pad support plate No.2.
10. REMOVE REAR DISC BRAKE BUSH DUST BOOT
(a) TMC made:
Remove the rear disc brake bush dust boot.
(b) TMMK made:
Remove the 2 rear disc brake bush dust boots.
To Next Page
Loading...
Need help?
General
