Toyota 2002 Camry - Thermostat (2 AZ-FE) Replacement

1602X–02
A59903
1010
B11281
–COOLING THERMOSTAT (2AZ–FE)
16–11
1830Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
THERMOSTAT (2AZ–FE)
REPLACEMENT
1. DRAIN COOLANT (See page 16–6)
2. REMOVE WATER INLET
(a) Remove 2 nuts, and disconnect the water inlet from the
cylinder block.
3. REMOVE THERMOSTAT
4. INSTALL THERMOSTAT
(a) Install a new gasket to the thermostat.
(b) Install the thermostat with the jiggle valve upward.
HINT:
The jiggle valve may be set within 10 on either side of the pre-
scribed position.
5. INSTALL WATER INLET
(a) Install the water inlet with 2 nuts.
Torque: 9 N⋅m (92 kgf⋅cm,
80 in.⋅lbf)
6. ADD COOLANT (See page 16–6)
7. INSPECT CHECK ENGINE COOLANT LEAK (See page 16–1)