Toyota 2002 Camry - V (Cooler Compressor to Crankshaft Pulley) Belt No.1 Replacement

550BU–01
I30370
Bolt C
Bolt A
Bolt B
I30370
I30370
Measuring
Position
Bolt B
N01881
DENSO Boroughs
–HEATER & AIR CONDITIONER V (COOLER COMPRESSOR TO CRANKSHAFT
PULLEY) BELT NO.1
55–21
2336Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY)
BELT NO.1
REPLACEMENT
1. REMOVE V (COOLER COMPRESSOR TO
CRANKSHAFT PULLEY) BELT NO.1
(a) Loosen the bolt C.
(b) Loosen the bolt A.
(c) Loosen the bolt B and remove the cooler V belt No. 1.
2. INSTALL V (COOLER COMPRESSOR TO
CRANKSHAFT PULLEY) BELT NO.1
(a) Temporarily install the cooler V belt No. 1 as illustrated.
3. ADJUST V (COOLER COMPRESSOR TO
CRANKSHAFT PULLEY) BELT NO.1
(a) Apply drive belt tension by turning the bolt B.
Drive belt tension:
New Belt: 165  27 lbf
Used belt: 88  22 lbf
HINT:
 ”New belt” refers to a belt which has been used less than
5 minutes on a running engine.
 ”Used belt” refers to a belt which has been used on a run-
ning engine for 5 minutes or more.
 After installing the drive belt, check that it fits properly in
the ribbed grooves.