Toyota 2002 Camry - Rear Axle Carrier Sub-Assy LH Replacement

3006J–04
C83017
C83018
–DRIVE SHAFT / PROPELLER SHAFT REAR AXLE CARRIER SUB–ASSY LH
30–31
1985Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
REAR AXLE CARRIER SUB–ASSY LH
REPLACEMENT
HINT:
 COMPONENTS: See page 30–4
 Replace the RH side by the same procedures with the LH side.
1. REMOVE REAR WHEEL
2. REMOVE STRUT ROD ASSY REAR
(See page 27–19)
3. DISCONNECT REAR DISC BRAKE CALIPER ASSY LH(DISC REAR BRAKE TYPE)
(See page 30–28)
4. REMOVE REAR DISC(DISC REAR BRAKE TYPE)
5. REMOVE REAR BRAKE DRUM SUB–ASSY(DRUM REAR BRAKE TYPE)
6. DISCONNECT SKID CONTROL SENSOR WIRE(W/ ABS)
7. DISCONNECT REAR BRAKE TUBE NO.4(DRUM REAR BRAKE TYPE)
(a) Using SST, disconnect the rear brake tube No.4 from the LH front or upper rear wheel brake cylinder
assy.
SST 09023–00100
8. REMOVE REAR AXLE HUB & BEARING ASSY LH
(See page 30–28)
9. DISCONNECT REAR SUSPENSION ARM ASSY NO.2
LH
(a) Remove the bolt, nut and rear suspension arm assy No.2
LH from the rear axle carrier sub–assy LH.
HINT:
While fixing the nut, turn and remove the bolt.
10. DISCONNECT REAR SUSPENSION ARM ASSY NO.1
LH
(a) Remove the bolt, nut and rear suspension arm assy No.1
LH from the rear axle carrier sub–assy LH.
HINT:
While fixing the nut, turn and remove the bolt.