14062–02
A36642
A13397
A13400
Front Mark
A52515
–ENGINE MECHANICAL CYLINDER BLOCK (2AZ–FE)
14–119
1643Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
CYLINDER BLOCK (2AZ–FE)
OVERHAUL
1. INSPECT CONNECTING ROD THRUST CLEARANCE
(a) Using a dial indicator, measure the thrust clearance while
moving the connecting rod back and forth.
Standard thrust clearance:
0.160 – 0.362 mm (0.0063 – 0.0143 in.)
Maximum thrust clearance: 0.362 mm (0.0143 in.)
(b) If the thrust clearance is greater than maximum, replace
the connecting rod assembly(s). If necessary, replace the
crankshaft.
2. INSPECT CONNECTING ROD OIL CLEARANCE
HINT:
The connecting rod cap bolts are tightened in 2 progressive
steps.
(a) Check the matchmarks on the connecting rod and cap are
aligned to ensure correct reassembly.
HINT:
The matchmarks on the connecting rods and caps are for en-
suring correct reassembly.
(b) Using a 12 mm socket wrench, remove the 2 connecting
rod cap bolts.
(c) Clean the crank pin and bearing.
(d) Check the crank pin and bearing for pitting and scratches.
(e) Lay a strip of plastigage on the crank pin.
(f) Check that the front mark of the connecting rod cap is fac-
ing in the correct direction.
(g) Apply a light coat of engine oil on the threads and under
the heads of the connecting rod cap bolts.
(h) Using a 12 mm socket wrench, tighten the bolts in several
passes by the specified torque.
Torque: 25 N⋅m (250 kgf⋅cm, 18 ft⋅lbf)
To Next Page
Loading...
