Toyota 2002 Camry - Install Valve Stem Oil O Seal or Ring; Install Intake Valve

Intake Side Exhaust Side
Gray
Black
A52449
SST
A36639
SST
Wooden Blocks
A52444
Vinyl Tape
Valve Stem
A13888
–ENGINE MECHANICAL CYLINDER HEAD ASSY (2AZ–FE)
14–117
1641Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
26. INSTALL VALVE STEM OIL O SEAL OR RING
(a) Apply a light coat of engine oil on new valve stem seals.
NOTICE:
Pay much attention assembling the oil seal for intake and
exhaust. Assembling the wrong one may cause a failure.
HINT:
The intake valve oil seal is gray and the exhaust valve oil seal
is black.
(b) Using SST, push in a the oil seal.
SST 09201–41020
27. INSTALL INTAKE VALVE
(a) Install the parts below to the cylinder head.
1 Intake valve
2 Spring
3 Retainer
(b) Using SST and wooden blocks, compress and install 2
valve spring retainer locks.
SST 09202–70020 (09202–00010)
(c) Using a plastic–faced hammer and the valve stem (not in
use) tip wound with vinyl tape, lightly tap the valve stem
tip to ensure a proper fit.
NOTICE:
Be careful not to damage the valve stem tip.