Toyota 2002 Camry - Inner Rear View Mirror Assy Pre-Check

700B5–01
Comp Switch
On Duration
Normal Mode
Pressed
Compass Non–display Mode
Pressed for 3 sec.
6. Zone Setting Mode
Ignition switch ON.
Pressed for 6 sec.
Zone area +1
Comp Switch ON
7. Calibration Mode
Leaving it untouched
for a while
Normal Mode
–WINDSHIELD/WINDOWGLASS/MIRROR INNER REAR VIEW MIRROR ASSY
70–27
2560Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
PRE–CHECK
1. SELECTING COMPASS DISPLAY MODE
(a) The comp switch allows you to select a Display or Non–display mode of the compass.
2. SETTING ZONE
(a) Deviation between the ”magnetic north” and ”actual north” differs depending on the location. There-
fore, adjustment of the magnetism is required. Since the magnetic condition differs according to the
area where the vehicle is used, it is necessary for each user to set the zone. (Refer to ”Compass Zone
Map”). The zone setting can be changed using the comp switch of the inner mirror.
3. PERFORMING CALIBRATION
(a) Because each vehicle has its own magnetic field, calibration should be performed for each vehicle.
This compass function is used when storing the record of the vehicle’s magnetic field.
4. WHEN COMPASS MAGNETIZED:
(a) A compass could be magnetized during shipping by vessels or freight cars. Before delivery, therefore,
make sure to perform calibration and ensure that calibration is done properly. If it cannot be done (can-
not be complete in spite of driving around several times), it may be caused by magnetization. Demag-
netize the vehicle using a demagnetizer and perform calibration again.
5. SETTING COMPASS