760BP–03
B56185
Protective
Tape
Clip
–EXTERIOR/INTERIOR TRIM ROOF DRIP SIDE FINISH MOULDING CENTER LH
76–11
2714Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
ROOF DRIP SIDE FINISH MOULDING CENTER LH
REPLACEMENT
HINT:
Installation is in the reverse order of the removal. But the installation is indicated only when it has a
point.
In the RH side, work in the same procedure as in the LH side.
1. REMOVE ROOF DRIP SIDE FINISH MOULDING
CENTER LH
(a) Tape the circumference of the moulding for protection.
(b) Using a remover for the roof moulding, release the en-
gagements of the clips both in the front and rear ends of
the moulding, and then remove the roof drip side finish
moulding.
NOTICE:
Do not remove the clips.
If the clips are damaged or removed accidentally, ex-
change them for supplied ones.
2. INSTALL ROOF DRIP SIDE FINISH MOULDING CLIP NO.1
NOTICE:
Only when exchanging the clips.
(a) Remove the adhesive tape that remains on the mounting surface of the body, and then clean the sur-
face with white gasoline.
(b) Heat up the clip installation surfaces of the body with a heat light.
Body: 40 – 60C (104 – 140F)
Moulding: 20 – 30C (68 – 86F)
NOTICE:
Do not heat the moulding excessively.
(c) Set the supplied clips into the positions as shown in the illustration, and press–fit those clips by hand
to install them.
(d) Install the moulding when 30 minutes or more have passed after press–fitting the clips.
HINT:
Initial hardening time: 30 minutes
Perfect hardening time: 24 hours
To Next Page
Loading...
