Toyota 2002 Camry - Floor Shift Cable Transmission Control Select Replacement

4104W–01
D26291
Select Cable
Retainer
Shift Cable
Grommet
D26291
Select Cable
Retainer
Shift Cable
Grommet
–MANUAL TRANSMISSION/TRANSAXLE FLOOR SHIFT CABLE TRANSMISSION CONTROL
SELECT
41–9
2139Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
FLOOR SHIFT CABLE TRANSMISSION CONTROL SELECT
REPLACEMENT
1. REMOVE INSTRUMENT PANEL SAFETY PAD SUB–ASSY
(See page 71–12)
2. REMOVE AIR CONDITIONING RADIATOR ASSY
(See page 55–29)
3. REMOVE AIR BAG SENSOR ASSY CENTER
(See page 60–56)
4. REMOVE FLOOR SHIFT CABLE TRANSMISSION
CONTROL SELECT
(a) Remove the clip and washer and separate the top of the
select cable from the transaxle.
(b) Remove the clip and select cable from the control cable
bracket.
(c) Turn the lock and separate the select cable from the shift
lever retainer.
(d) Remove the clip and separate the top of the select cable
from the shift lever assy.
(e) Remove the 2 retainer set bolts from the floor.
(f) Separate the retainer from the grommet.
(g) Remove the select cable from the grommet.
(h) Remove the select cable through the floor hole and re-
tainer.
5. INSTALL FLOOR SHIFT CABLE TRANSMISSION
CONTROL SELECT
(a) Put the select cable through the floor hole and retainer.
(b) Install the select cable to the grommet.
(c) Install the retainer to the grommet.
NOTICE:
Fit 3 projections of the grommet into 3 holes of the retainer.
(d) Install the 2 retainer set bolts.
Torque: 5.0 N⋅m (51 kgf⋅cm, 44 in.⋅lbf)