6007T–01
C93765
C84229
60–58
–SUPPLEMENTAL RESTRAINT SYSTEM AIR BAG FRONT RH SENSOR
2441Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
REPLACEMENT
HINT:
COMPONENTS: See page 60–57
1. PRECAUTION(See page 60–1)
2. DISCONNECT BATTERY NEGATIVE TERMINAL(See page 60–1)
3. REMOVE ENGINE UNDER COVER RH
4. REMOVE AIR BAG FRONT RH SENSOR
(a) Remove the bolt and front airbag sensor RH.
(b) Disconnect the connector from the front airbag sensor
RH.
HINT:
Insert a screw driver in any of the three opening sections of the
sensor and slide the sensor to disconnect it from the connector.
5. INSPECT AIR BAG FRONT RH SENSOR
(See page 60–9)
6. INSTALL AIR BAG FRONT RH SENSOR
(a) Check that the ignition switch trun OFF.
(b) Check that the battery negative (–) terminal is disconnected.
NOTICE:
Do not start the operation for 90 seconds after removing the terminal.
(c) Install the front airbag sensor RH with the bolt.
Torque: 17.5 N⋅m (178 kgf⋅cm, 13 ft⋅lbf)
(d) Connect the connector to the front airbag sensor RH.
(e) Check that no play is identified.
7. INSPECT SRS WARNING LIGHT(See page 05–690)
To Next Page
Loading...
