–DRIVE SHAFT / PROPELLER SHAFT REAR AXLE CARRIER SUB–ASSY LH
30–33
1987Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
16. INSTALL REAR BRAKE TUBE NO.4(DRUM REAR BRAKE TYPE)
(a) Using SST, install the rear brake tube No.4 to the LH front or upper rear wheel brake cylinder assy.
SST 09023–00100
Torque: 15.2 N⋅m (155 kgf⋅cm,11 ft⋅lbf)
17. INSTALL SKID CONTROL SENSOR WIRE(W/ ABS)
18. INSTALL REAR DISC(DISC REAR BRAKE TYPE)
19. INSTALL REAR DISC BRAKE CALIPER ASSY LH(DISC REAR BRAKE TYPE)
(See page 30–28)
20. INSTALL REAR BRAKE DRUM SUB–ASSY(DRUM REAR BRAKE TYPE)
21. TEMPORARY TIGHTEN STRUT ROD ASSY REAR
(See page 27–19)
22. STABILIZE SUSPENSION(See page 27–19)
23. FULLY TIGHTEN REAR SUSPENSION ARM ASSY NO.1 LH
(See page 27–10)
24. FULLY TIGHTEN REAR SUSPENSION ARM ASSY NO.2 LH
(See page 27–14)
25. FULLY TIGHTEN STRUT ROD ASSY REAR
(See page 27–19)
26. FILL RESERVOIR WITH BRAKE FLUID(DRUM REAR BRAKE TYPE)
27. BLEED MASTER CYLINDER(DRUM REAR BRAKE TYPE)(See page 32–4)
SST 09023–00100
28. BLEED BRAKE LINE(DRUM REAR BRAKE TYPE)
29. CHECK FLUID LEVEL IN RESERVOIR(DRUM REAR BRAKE TYPE)
30. CHECK BRAKE FLUID LEAKAGE(DRUM REAR BRAKE TYPE)
31. INSTALL REAR WHEEL
Torque: 103 N⋅m (1,050 kgf⋅cm, 76 ft⋅lbf)
32. INSPECT AND ADJUST REAR WHEEL ALIGNMENT(See page 27–3)
33. CHECK ABS SPEED SENSOR SIGNAL(W/ ABS)
w/ VSC (See page 05–452)
w/o VSC (BOSCH MADE) (See page 05–363)
w/o VSC (DENSO MADE) (See page 05–404)
To Next Page
Loading...
