760CA–01
B56420
Protective Tape
–EXTERIOR/INTERIOR TRIM FRONT DOOR BELT MOULDING ASSY LH
76–9
2712Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
FRONT DOOR BELT MOULDING ASSY LH
REPLACEMENT
HINT:
Installation is in the reverse order of the removal. But the installation is indicated only when it has a
point.
In the RH side, work in the same procedure as in the LH side.
1. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSY
(See page 75–8)
2. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH
(See page 75–8)
3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH
(See page 75–8)
4. REMOVE FRONT DOOR TRIM BOARD SUB–ASSY LH
(See page 75–8)
5. REMOVE OUTER REAR VIEW MIRROR ASSY LH
(See page 75–8)
6. REMOVE FRONT DOOR BELT MOULDING ASSY LH
(a) Put protective tape under the front door belt moulding.
(b) Using a moulding remover or scraper, remove the front
door belt moulding.
HINT:
Tape the scraper tip before use.
To Next Page
Loading...
