Toyota 2002 Camry - Rear Door Adjustment

7509B–01
B50717
Centering Bolt
Standard Bolt
B56579
5.1 (0.201)1.5 (0.059)
01.5
(0.059)
5.6 (0.220)1.5 (0.059)
4.6 (0.181)1.5 (0.059)
01.5 (0.059)
mm (in.)
75–14
–ENGINE HOOD/DOOR REAR DOOR
2694Author: Date:
2002 CAMRY REPAIR MANUAL 185W (RM881U)
ADJUSTMENT
HINT:
 Installation is in the reverse order of the removal. But the installation is indicated only when it has a
point.
 In the RH side, work in the same procedure as in the LH side.
HINT:
Since the centering bolt is used as a door hinge set bolt, the
door can not be adjusted with it on. Substitute a bolt with washer
for the centering bolt.
1. INSPECT REAR DOOR PANEL SUB–ASSY LH
(a) Check that the clearance is within the standard value.
2. REMOVE FRONT DOOR SCUFF PLATE LH(See page 76–20)
3. REMOVE REAR DOOR SCUFF PLATE LH(See page 76–20)
4. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH(See page 76–20)
5. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH(See page 76–20)
6. REMOVE CENTER PILLAR GARNISH LOWER LH(See page 76–20)