Toyota 2002 Camry - Inspect Crankshaft Bearing Cap Set Bolt; Install Ring Pin

ZF6928
EM6347
A15065
A
B
14
13
12
6 (Ring Pin A)
5 (Ring Pin B)
A
A
B
B
12
Upper Side Bottom Side
A53009
–ENGINE MECHANICAL CYLINDER BLOCK (2AZ–FE)
14–127
1651Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
(d) Using a micrometer, measure the diameter of each crank
pin.
Diameter: 47.990 – 48.000 mm (1.8894 – 1.8898 in.)
(e) Check each crank pin for taper and out–of–round as
shown.
Maximum taper and out–of–round:
0.003 mm (0.0001 in.)
24. INSPECT CRANKSHAFT BEARING CAP SET BOLT
(a) Using vernier calipers, measure the tension portion diam-
eter of the bolt.
Standard diameter: 7.5 – 7.6 mm (0.295 – 0.299 in.)
Minimum diameter: 7.2 mm (0.283 in.)
If the diameter is less than minimum, replace the bolt.
25. INSTALL RING PIN
(a) Using a plastic–faced hammer, tap into the ring pin.
Standard protrusion:
Ring pin A 6 mm (0.236 in.)
Ring pin B 5 mm (0.197 in.)