Toyota 2002 Camry - Page 524

C83019
C83019
C83018
C83017
30–32
–DRIVE SHAFT / PROPELLER SHAFT REAR AXLE CARRIER SUB–ASSY LH
1986Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
11. REMOVE REAR AXLE CARRIER SUB–ASSY LH
(a) Remove the 2 bolts, nuts and rear axle carrier sub–assy
LH from the shock absorber assy rear LH.
NOTICE:
When removing bolt, stop the bolt from rotating and loosen
the nut.
12. INSTALL REAR AXLE CARRIER SUB–ASSY LH
(a) Install the rear axle carrier sub–assy LH with the 2 bolts
and nuts.
Torque: 255 N⋅m (2,600 kgf⋅cm, 188 ft⋅lbf)
NOTICE:
When installing bolt, stop the bolt from rotating and torque
the nut.
HINT:
Insert the bolt from the rear side of the vehicle and install the
nut.
13. TEMPORARY TIGHTEN REAR SUSPENSION ARM
ASSY NO.1 LH
(a) Install the rear suspension arm No.1 to the rear axle carri-
er sub–assy LH with the bolt and nut, temporarily tighten
the bolt.
HINT:
Insert the bolt from the front side of the vehicle and while fixing
the nut, turn and install the bolt.
14. TEMPORARY TIGHTEN REAR SUSPENSION ARM
ASSY NO.2 LH
(a) Install the rear suspension arm No.2 to the rear axle carri-
er sub–assy LH with the bolt and nut, temporarily tighten
the bolt.
HINT:
Insert the bolt from the rear side of the vehicle and while fixing
the nut, turn and install the bolt.
15. INSTALL REAR AXLE HUB & BEARING ASSY LH
(See page 30–28)