B56902
2–Piece Type
1–Piece Type
B56906
Retainer
Stopper
Piano Wire
BO3986
70–8
–WINDSHIELD/WINDOWGLASS/MIRROR WINDSHIELD GLASS
2541Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
17. REMOVE WINDSHIELD GLASS
HINT:
There is a case where a 1–piece type and a 2–piece type of
stoppers are installed in a vehicle type.
(a) Push a piano wire through between the body and glass
from the interior.
(b) Apply protective tape to the outer surface to keep the sur-
face from being scratched.
(c) Tie both wire ends to wooden blocks or similar objects.
NOTICE:
w/ Curtain shield airbag:
When working around the curtain shield airbag,be
careful not to damage the airbag.
When separating the glass, take care not to damage
the paint and interior/exterior ornaments.
To prevent the piano wire to be cut, do not cross it.
(d) Cut the adhesive by pulling the piano wire around it.
(e) Using a suction rubber, remove the glass.
NOTICE:
Leave as much adhesive on the body as possible when cut-
ting off the glass.
18. CLEAN WINDSHIELD GLASS
(a) Using a scraper, remove the damaged stoppers, dam and
adhesive sticking to the glass.
(b) Clean the outer circumference of the glass with white gas-
oline.
NOTICE:
Do not touch the glass after cleaning it.
Be careful not to damage the body.
19. INSTALL WINDSHIELD GLASS STOPPER NO.1
(a) Install 2 new windshield glass stoppers No.1 to the body.
To Next Page
Loading...
