B56909
Stopper
Piano Wire
BO3986
B56894
Stopper
A
B
Ceramic Line
70–14
–WINDSHIELD/WINDOWGLASS/MIRROR BACK WINDOW GLASS
2547Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
(a) Push a piano wire through between the body and glass
from the interior.
(b) Apply protective tape to the outer surface to keep the sur-
face from being scratched.
(c) Tie both wire ends to wooden blocks or similar objects.
NOTICE:
When separating the glass, take care not to damage
the paint and interior/exterior ornaments.
To prevent the piano wire to be cut, do not cross it.
(d) Cut the adhesive by pulling the piano wire around it.
(e) Using a suction rubber, remove the glass.
NOTICE:
Leave as much adhesive on the body as possible when cut-
ting off the glass.
14. CLEAN BACK WINDOW GLASS
(a) Using a scraper, remove the damaged spacers and clips,
dam and adhesive sticking to the glass.
(b) Clean the outer circumference of the glass with white gas-
oline.
NOTICE:
Do not touch the glass after cleaning it.
Be careful not to damage the body.
15. INSTALL BACK WINDOW GLASS STOPPER NO.1
(a) Install 2 new windshield glass stoppers No.1 to the body.
16. INSTALL BACK WINDW GLASS STOPPER NO.2
(a) Coat the installation part of the stopper with Primer G.
NOTICE:
Dry the primer coating for 3 minutes or more.
Do not apply too much primer.
(b) Install 2 new windshield glass stoppers No.2 onto the
glass as shown in the illustration..
A: 11.2 mm (0.441 in.)
B: 40 mm (1.57 in.)
To Next Page
Loading...
