Toyota 2002 Camry - Page 1106

–INSTRUMENT PANEL/METER COMBINATION METER
71–5
2568Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
7. INSPECT SEAT BELT WARNING LIGHT (Driver’s seat)
(a) Check the operation.
(1) Turn the ignition switch to ON and check that the warning light lights up.
(2) Fasten the outer belt to the inner belt and check that the warning light lights out.
(3) Disconnect the connector from the buckle switch and ground terminal on the wire harness side
connector.
(4) Turn the ignition switch to ON and check that the warning light lights up.
8. INSPECT LOW OIL PRESSURE WARNING LIGHT
(a) Inspect the circuit.
(1) Disconnect the connector from the low oil pressure switch.
(2) Turn the ignition switch to ON.
(3) Connect the terminal of wire harness side connector and ground, then check the warning low
oil pressure warning light.
Low oil pressure warning light: Light on
9. INSPECT BRAKE WARNING LIGHT
(a) Inspect the parking brake warning light.
(1) Disconnect the connector from the parking brake switch and ground terminal on the wire harness
side connector.
(2) Turn the ignition switch to ON and check that the warning light lights up.
(b) Inspect the brake fluid level warning light.
(1) Disconnect the connector from the brake fluid level warning switch and connect terminals on the
wire harness side connector.
(2) Turn the ignition switch to ON and check that the warning light lights up.
10. INSPECT BRAKE FLUID LEVEL WARNING SWITCH
(a) Inspect the continuity.
(1) Remove the reservoir tank cap and strainer.
(2) Disconnect the connector.
(3) Check that the continuity exists between the terminals.
Float up (switch off): No continuity
(4) Use syphon, etc., to take fluid out of the reservoir tank.
(5) Check that the continuity exists between the terminals.
Float down (switch on): Continuity
(6) Pour the fluid back in the reservoir tank.
11. INSPECT DRIVER’S SEAT BELT WARNING BUZZER
(a) Check warning buzzer function.
(1) Turn the ignition switch to ON and check that the driver’s seat belt warning sounds if the driver’s
seat belt is not fastened.
(2) Check that the buzzer stop after about 4 to 8 seconds.
12. INSPECT KEY REMINDER WARNING BUZZER
(a) Check warning buzzer function.
(1) Turn the ignition switch to OFF and check that the key reminder warning sounds if the ignition
key is insert the key cylinder and front diriver side door is opened.