Toyota 2002 Camry - Page 1136

B57684
Listing Pocket
Seat Heater
Tack Pin
Seat Heater
Tack Pin
Center
Seat Wire
B: Install the tack pins under the wire.
C: Aline the seat heater and the end of listing pocket.
Seat Back Cover
A: 15 mm (0.59 in.)
A
B
C
b
a
b
bb
bb bb
bb
bb
a
a
a
Tack pins should not be beyond the sean.
b – b:
a – a:
Tack Pin
Seat Heater
Tack Pin
Seat Back Cover
–SEAT FRONT SEAT (Power Seat for TMC Made)
72–9
2598Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
19. REMOVE FRONT SEAT BACK HEATER ASSY LH (W/ SEAT HEATER)
(a) Cut off the tack pins which fasten the seat heater, and then remove the front seat heater assembly LH
from the front seat back cover.
NOTICE:
Be careful not to damage the seat back cover.
20. REMOVE LUMBAR SUPPORT ADJUSTER ASSY LH
(a) Remove the 3 screws and the lumber support adjuster assembly LH.
21. REMOVE POWER SEAT MOTOR
(a) Remove the 2 screws each to remove the sliding motor, reclining motor, front vertical motor and rear
lifter motor.
22. INSTALL FRONT SEAT BACK HEATER ASSY LH (W/ SEAT HEATER)
(a) Set the seat heater to the seat back cover.
(b) Install the front seat heater assembly to the seat back cover with the 8 tack pins.
NOTICE:
 Do not substitute other metal parts for tack pins.
23. INSTALL SEPARATE TYPE FRONT SEAT BACK COVER
NOTICE:
 For a vehicle with side airbag, if the seat back cover has damage, the side airbag may not acti-
vate normally, and therefore it is necessary to replace the seat back cover.
 For a vehicle with side airbag, if the side airbag has damage replace the pad and the frame with
new ones.
 For a vehicle with side airbag, the side airbag may not activate normally unless the seat back
cover is securely installed, as shown in the following procedures.