Toyota 2002 Camry - Page 1205

1
45 6 87
2
3
B56738
Wire Harness Side
–SLIDING ROOF/CONVERTIBLE SLIDING ROOF SYSTEM
74–3
2667Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
(3) When operating the roof glass to the fully close position via the AUTO close or down, check that
the glass movement will be reversed by detecting the handle, and keep moving by about 200
mm open or up and stop then.
HINT:
 The reverse movement when the glass is sliding will stop in 200 mm open or before the fully open posi-
tion (in max. 20 seconds).
 The reverse movement when the glass is tilting down will stop in the fully up position or in 2 seconds.
2. INSPECT SLIDING ROOF RELAY AND SWITCH
(TMMK MADE)
(a) Inspect the sliding roof relay and switch operation.
(1) Disconnect the connector from the sliding roof relay
and inspect the connector on the wire harness side.
Standard:
Terminal No. Wiring color Condition Specified condition
5 ⇔ Body ground W–B ⇔ Body ground Constant Continuity
7 ⇔ 5 L–W ⇔ W–B Constant 10 – 14 V
3 ⇔ 5 R–L ⇔ W–B Ignition switch OFF → ON 0 V → 10 – 14 V
1 ⇔ 5 R–W ⇔ W–B Sliding roof switch → OPEN or DOWN No continuity → Continuity
2 ⇔ 5 R–Y ⇔ W–B Sliding roof switch → CLOSE or UP No continuity → Continuity
HINT:
If the value is not as specified, there may be a malfunction in the wire harness side.
(2) Connect the connector, and inspect the voltage and continuity between each terminal of the con-
nector and the body ground.
Standard:
Terminal No. Wiring color Condition Specified condition
1 ⇔ 5 R–W ⇔ W–B
Ignition switch OFF → ON
Sliding roof switch → OPEN or DOWN
10 – 14 V → 0 V
2 ⇔ 5 R–Y ⇔ W–B
Ignition switch OFF → ON
Sliding roof switch → CLOSE or UP
10 – 14 V → 0 V
HINT:
If the value is not as specified, the sliding roof drive gear may be defective.