7404C–02
–SLIDING ROOF/CONVERTIBLE SLIDING ROOF SYSTEM
74–7
2671Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
RESET
1. RESET SLIDING ROOF POSITION
NOTICE:
When the battery negative (–) terminal is disconnected or PWR No.1 fuse is removed
due to the repair,
the sliding roof position memory is erased. After reconnecting the battery negative (–) terminal, make
sure to reset the zero point.
If the reset is not performed, the sliding roof automatic operation will not function.
Vehicle Condition Procedure for reset
TMC made CAMRY
When the Battery negative (–) terminal is disconnected.
When component parts of sliding roof are replaced.
When the ”PWR No,1” fuse is removed.
Reset A
When the sliding roof dose not stop at the fully closed position even if the auto close switch is
operated.
Reset B
When the Battery negative (–) terminal is disconnected.
When the ”PWR No,1” fuse is removed.
Reset A
TMMK made CAMRY
When component parts of sliding roof are replaced.
When the sliding roof dose not stop at the fully closed position even if the auto close switch is
operated.
Reset C
(a) Reset A
(1) To reset the zero point for the sliding roof, push and hold the switch on the ”TILT UP” side until
the sliding roof tilts all the way up and down a little automatically.
(2) Confirm ”one–touch side open and close” and ”one–touch tilt up and down” functions by pushing
the switch briefly to the ”SLIDE–OPEN” and ”TILT–UP” sides.
(b) Reset B
(1) Push and hold the switch on the ”TILT UP/CLOSE” side until the sliding roof stops.
(2) Continue to push and hold the switch on the ”TILT UP/CLOSE” side for 10 seconds or more. The
sliding roof will close to the fully closed position.
(3) Continue to push and hold the switch on the ”TILT UP/CLOSE” side until the sliding roof tilts all
the way up and down a little automatically.
(4) Confirm ”one–touch side open and close” and ”one–touch tilt up and down” functions by pushing
the switch briefly to the ”SLIDE–OPEN” and ”TILT–UP” sides.
(c) Reset C
(1) To reset the zero point for the sliding roof, push and hold the switch on the ”TILT UP” side until
the sliding roof tilts all the way up and down a little automatically.
(2) Release the switch, and within 5 seconds re–push and hold the switch on the ”TILT UP/CLOSE”
side.
(3) The sliding roof will automatically move to full slide open and then reverse to the close position.
(4) Release the switch.
(5) Confirm ”one–touch side open and close” and ”one–touch tilt up and down” functions by pushing
the switch briefly to the ”SLIDE–OPEN” and ”TILT–UP” sides.
To Next Page
Loading...
