B00347
New O–ring
Delivery Pipe
Injector
CORRECT
WRONG
Grommet
FI6372
A62371
Delivery Pipe
Spacer
Insulator
O–ring
Grommet
A60083
Fuel Pipe
Clamp No.1
A
A
B12941
–FUEL FUEL SYSTEM (1MZ–FE)
11–27
1471Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
(5) Put a container under the connection.
(b) Observe these precautions when removing and installing
the injector.
(1) Never reuse the O–ring.
(2) When placing the new O–rings on the injector, take
care not to damage it in any way.
(3) Coat a new O–rings with spindle oil or gasoline be-
fore installing. Never use engine, gear or brake oil.
(c) Install the injector to the delivery pipe and intake manifold,
as shown in the illustration. Before installing the injector,
be sure to apply spindle oil or gasoline on the place where
a delivery pipe or an intake manifold touches an O–ring
of the injector.
(d) Observe these precautions when disconnecting the fuel
tube connector.
(1) Remove the fuel pipe clamp No.1.
(2) Check if there is any dirt like mud on the pipe and
around the connector before disconnecting them
and clean the dirt away.
(3) Disconnect the connector from the hose while
pinching part A with fingers as shown in the illustra-
tion.
To Next Page
Loading...
