Seal Packing
6mm
A52522
B12056
Rib
Wire Harness
Clamp
A52071
SST
A52486
–ENGINE MECHANICAL CHAIN (2AZ–FE)
14–85
1609Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
45. INSTALL OIL PAN SUB–ASSY
NOTICE:
Remove any oil from the contact surface.
Install the oil pan within 3 minutes after applying seal
packing.
Do not start the engine 2 hours after installing.
(a) Remove any old packing (FIPG) material and be careful
not to drop any oil on the contact surface of the cylinder
block and oil pan.
(b) Apply seal packing in the shape of bead (Diameter 3 – 4
mm (0.157 in.)) as shown in the illustration, and install the
oil pan.
Seal packing:
Part No. 08826–00080 or equivalent
(c) Install the oil pan with the 12 bolts and 2 nuts.
Torque: 9.0 N⋅m (92 kgf⋅cm, 80 in.⋅lbf)
46. INSTALL CHAIN TENSIONER ASSY NO.1
(See page 14–88)
47. INSTALL CRANK POSITION SENSOR
(a) Install the bolt and crankshaft position sensor.
Torque: 9.0 N⋅m (92 kgf⋅cm, 80 in.⋅lbf)
(b) Confirm the wire harness of the crank position sensor is
placed as shown in the illustration.
48. INSTALL CRANKSHAFT PULLEY
(a) Install the crankshaft pulley (TMC made).
(1) Align the pulley set key with the key groove of the
pulley, and side on the pulley.
SST 09213–54015 (91651–60855), 09330–00021
(2) Using SST, install the pulley bolt.
Torque: 170 N⋅m (1,733 kgf⋅cm, 125 ft lbf)
To Next Page
Loading...
