Toyota 2002 Camry - Page 429

Upward
A51919
A38024
–STARTING & CHARGING GENERATOR ASSY (2AZ–FE)
19–19
1891Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
14. INSTALL GENERATOR REGULATOR ASSY
(a) Install the 3 screws and voltage regulator.
Torque: 2.0 N⋅m (20 kgf⋅cm,
18 in.⋅lbf)
15. INSTALL GENERATOR BRUSH HOLDER ASSY
(a) Install the 2 screws and brush holder.
Torque: 2.0 N⋅m (20 kgf⋅cm, 18 in.⋅lbf)
NOTICE:
Be careful of the holder installation direction.
(b) Install the brush cover.
(c) Install the end cover and plate terminal with the bolt and
3 nuts.
Torque:
Nut 4.4 N⋅m (45 kgf⋅cm, 39 in.⋅lbf)
Bolt 3.9 N⋅m (39 kgf⋅cm, 35 in.⋅lbf)
(d) Install the terminal insulator with the nut.
Torque: 4.1 N⋅m (42 kgf⋅cm, 36 in.⋅lbf)
16. INSTALL GENERATOR PULLEY
SST 09820–63010 (09820–06010, 09820–06020)
HINT:
SST1 – A, B 09820–06010
SST2 09820–06020
(a) Install the pulley to the rotor shaft by tightening the pulley
nut by hand.
(b) Hold SST 1 – A with a torque wrench, and tighten SST 1
– B clockwise to the specified to torque.
Torque: 39 N⋅m (400 kgf⋅cm, 29 ft⋅lbf)
NOTICE:
Check that SST is secured to the pulley shaft.