Toyota 2002 Camry - Page 437

A56443
Length
A58583
No Continuity
A58586
A58375
Terminal C
Terminal 50
Continuity
A58376
Terminal 50
Continuity
–STARTING & CHARGING STARTER ASSY (1MZ–FE)
19–27
1899Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
5. INSPECT STARTER COMMUTATOR END FRAME
ASSY
(a) Using vernier calipers, measure the brush holder length.
Standard length: 9.0 mm (0.354 in.)
Maximum length: 4.0 mm (0.158 in.)
If the length is less than minimum, replace the starter commuta-
tor end frame assy.
(b) Check the brush holder.
(1) Using an ohmmeter, check that there is no continu-
ity between the positive (+) and negative (–) brush
holders.
If the there is continuity repair or replace the starter commutator
end frame assy.
6. INSPECT REPAIR SERVICE STARTER KIT
(a) Check the plunger.
(1) Push in the plunger and check that it returns quickly
to its original position.
If necessary, replace the repair service starter kit.
(b) Check the pull–in coil for open circuit.
(1) Using an ohmmeter, check that there is continuity
between terminals 50 and C.
If there is no continuity, replace the repair service starter kit.
(c) Check whether the hold–in coil has an open circuit.
(1) Using an ohmmeter, check that there is continuity
between terminal 50 and the switch body.
If there is no continuity, replace the repair service kit.