Toyota 2002 Camry - Page 446

Wooden block
A66906
A59143
F
B
Ohmmeter
19–36
–STARTING & CHARGING GENERATOR ASSY (1MZ–FE)
1908Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
2. REMOVE GENERATOR BRUSH HOLDER ASSY
(a) Remove the nut and terminal insulator.
(b) Remove the bolt, 3 nuts, plate terminal and end cover.
(c) Remove the brush cover.
(d) Remove the 2 screws and brush holder.
3. REMOVE GENERATOR REGULATOR ASSY
(a) Remove the 3 screws and voltage regulator.
4. REMOVE GENERATOR HOLDER W/RECTIFIER
(a) Remove the 4 screws and rectifier holder.
5. REMOVE ALTERNATOR RECTIFIRE END FRAME
(a) Remove the rubber insulator.
(b) Remove the seal plate.
(c) Remove the 4 nuts.
(d) Using bearing puller set, remove the rectifier end frame.
6. REMOVE GENERATOR ROTOR ASSY
(a) Remove the alternator washer from the rotor.
(b) Remove the rotor from drive end frame.
NOTICE:
Do not drop the rotor.
7. INSPECT GENERATOR REGULATOR ASSY
(a) Using an ohmmeter, check the continuity between termi-
nals F and B.
Standard:
When the positive and negative poles between termi-
nals F and B are exchanged, there is continuity in one
way but no continuity in another way.
If the continuity is not as specified, replace the voltage regula-
tor.