Length
P13535
17 mm
Socket
Wrench
A51920
Inside
A51921
19–38
–STARTING & CHARGING GENERATOR ASSY (1MZ–FE)
1910Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
10. INSPECT BRUSH
(a) Using vernier calipers, measure the exposed brush
length.
Standard exposed length:
9.5 – 11.5 mm (0.374 – 0.453 in.)
Minimum exposed length: 1.5 mm (0.059 in.)
If the exposed length is less than minimum, replace the brush
holder assembly.
11. INSTALL GENERATOR ROTOR ASSY
(a) Install the generator rotor.
(b) Install the alternator washer to the rotor.
12. INSTALL ALTERNATOR RECTIFIRE END FRAME
(a) Using a 17 mm socket wrench and press, slowly press in
the rectifier end frame.
(b) Install the cord clip and the 4 nuts.
Torque: 4.5 N⋅m (46 kgf⋅cm, 39 in.⋅lbf) for without cord
clip
Torque: 5.4 N⋅m (55 kgf⋅cm, 47 in.⋅lbf) for with cord clip
(c) Install the seal plate on the rectifier end frame.
(d) Install the 4 rubber insulators on the lead wires.
NOTICE:
Be careful of the rubber insulators installation direction.
13. INSTALL GENERATOR HOLDER W/RECTIFIER
(a) Install the rectifier holder while pushing it with the 4 screws.
Torque: 2.9 N⋅m (30 kgf⋅cm,
26 in.⋅lbf)
14. INSTALL GENERATOR REGULATOR ASSY
(a) Install the 3 screws and voltage regulator.
Torque: 2.0 N⋅m (20 kgf⋅cm,
18 in.⋅lbf)
To Next Page
Loading...
