Toyota 2002 Camry - Page 506

F41033
SST
C91588
SST
W01994
Vinyl Tape
R10425
SST
30–14
–DRIVE SHAFT / PROPELLER SHAFT FRONT DRIVE SHAFT
1968Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
30. INSTALL FRONT DRIVE SHAFT DUST COVER LH
(a) Using SST and a press, install a new front drive shaft dust
cover LH.
SST 09527–10011
31. INSTALL FRONT DRIVE SHAFT LH HOLE SNAP RING
(a) Install a new front drive shaft LH hole snap ring.
32. INSTALL FRONT WHEEL BEARING DUST
DEFLECTOR LH NO.2(W/O ABS)
(a) Using SST and a press, install a new front wheel bearing
dust deflector LH No.2 until the distance from the tip of
front drive outboard joint shaft assy LH to the front wheel
bearing dust deflector LH No.2 reaches the specification,
as shown in the illustration.
SST 09387–00020
Distance: 13.5 – 13.8 mm (0.531 – 0.543 in.)
33. INSTALL OUTBOARD JOINT BOOT
HINT:
Before installing the boots, wrap the spline of the drive shaft
with vinyl tape to prevent the boots from being damaged.
(a) Temporarily install a new outboard joint boot with 2
clamps to the drive shaft.
(b) Pack the inboard joint shaft and boot with grease in the
boot kit.
Grease capacity:
1MZ–FE, 2AZ–FE(MT): 105 – 125 g (3.7 – 4.4 oz.)
2AZ–FE(AT): 100 – 120 g (3.5 – 4.2 oz.)
34. INSTALL FRONT AXLE OUTBOARD JOINT BOOT
CLAMP
(a) Mount drive shaft in a soft vise.
(b) Secure the 2 outboard joint boot clamps onto the boot.
(c) Place SST onto the outboard joint large boot clamp.
SST 09521–24010
(d) Tighten the SST so that the large clamp is pinched.
NOTICE:
Do not overtighten the SST.