Toyota 2002 Camry - Page 562

C88526
F41966
Cylinder Mounting
Cylinder Slide Pin
F41562
Cylinder Mounting
Cylinder Slide Pin
TMC made:
32–36
–BRAKE REAR DISC BRAKE
2024Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
NOTICE:
Do not screw the piston forcedly in the disc brake cylinder.
32. INSTALL CYLINDER BOOT
(a) Apply the lithium soap base glycol grease on a new cylinder boot.
(b) Install the cylinder boot to the disc brake cylinder.
HINT:
Install the boot securely to the grooves of the cylinder and piston.
(c) Using a screwdriver, install a new set ring.
NOTICE:
Do not damage the cylinder boot.
33. INSTALL REAR DISC BRAKE CYLINDER MOUNTING LH
(a) Install the cylinder mounting LH with the 2 bolts.
Torque:
TMC made: 61.8 N⋅m (630 kgf⋅cm, 46 ft⋅lbf)
TMMK made: 47 N⋅m (475 kgf⋅cm, 34 ft⋅lbf)
34. INSTALL REAR DISC BRAKE CYLINDER SLIDE PIN
(a) TMC made:
Using a hexagon wrench (8 mm), install the cylinder slide pin.
Torque: 39.2 N⋅m (400 kgf⋅cm, 29 ft⋅lbf)
(b) TMMK made:
Install the cylinder slide pin with the cylinder slide bush.
Torque: 43 N⋅m (440 kgf⋅cm, 32 ft⋅lbf)
35. INSTALL REAR DISC BRAKE CYLINDER SLIDE
BUSH(TMC MADE)
(a) Apply the lithium soap base glycol grease on a new cylin-
der slide bush.
(b) Install the cylinder slide bush to the disc brake cylinder
assy.
36. INSTALL REAR DISC BRAKE BUSH DUST BOOT
(a) TMC made:
Install the rear disc brake bush dust boot.
(1) Apply the lithium soap base glycol grease to seal
surface of a new bush dust boot.
(2) Install the bush dust boot to the cylinder slide pin.
(b) TMMK made:
Install the rear disc brake bush dust boot.
(1) Apply the lithium soap base glycol grease to seal
surface of a 2 new bush dust boots.
(2) Install the 2 bush dust boots to the each cylinder
slide pin.