C65911
Dimension B
C96139
A
A
A
B
B
C
C C
C
D25408
D25407
D25420
–AUTOMATIC TRANSMISSION / TRANS AUTOMATIC TRANSAXLE ASSY (2AZ–FE)
40–17
2092Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
(c) Using vernier calipers and a straight edge, measure the
dimension ”B” shown in the illustration and check that ”B”
is greater than ”A” measured in (b).
Standard: A + 1 mm or more
NOTICE:
Do not add the thickness of straight edge.
19. INSTALL AUTOMATIC TRANSAXLE ASSY
(a) Install the automatic transaxle and 9 bolts to the engine.
Torque:
Bolt A: 64 N⋅m (650 kgf⋅cm, 47 ft⋅lbf)
Bolt B: 46 N⋅m (470 kgf⋅cm, 34 ft⋅lbf)
Bolt C: 44 N⋅m (449 kgf⋅cm, 32 ft⋅lbf)
(b) Apply a few drops of adhesive to each 2 threads on the
tip of the 6 torque converter clutch mounting bolts.
Adhesive: Part No. 08833–00070, THREE BOND 1324
or equivalent
(c) Install the 6 torque converter clutch mounting bolts.
Torque: 41 N⋅m (420 kgf⋅cm, 30 ft⋅lbf)
HINT:
First install green colored bolt and then the other 5 bolts.
20. INSTALL FLYWHEEL HOUSING UNDER COVER
(a) Install the flywheel housing under cover.
21. INSTALL TRANSVERSE ENGINE ENGINE MOUNTING
BRACKET
(a) Install the engine mounting bracket FR and 3 bolts to the
automatic transaxle.
Torque: 64 N⋅m (653 kgf⋅cm, 47 ft⋅lbf)
To Next Page
Loading...
