Toyota 2002 Camry - Page 718

C90201
C92834
C90199
C92832
C90198
C92831
C83809
41–50
–MANUAL TRANSMISSION/TRANSAXLE MANUAL TRANSAXLE ASSY (E351)
2180Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
116. INSTALL CONTROL SHAFT COVER
(a) Coat the 4 bolts with sealant, install new gasket with con-
trol shaft cover with the bolt.
Sealant:
Part No. 08833–00080, THREE BOND 1344, LOCTITE
242 or equivalent
Torque: 20 N⋅m (204 kgf⋅cm, 15 ft⋅lbf)
117. INSTALL CONTROL SHIFT LEVER
(a) Install the control shift lever with shift outer lock pin to the
shift & select lever shaft.
(b) Install the spring washer with nat.
Torque: 6.4 N⋅m (65 kgf⋅cm, 57 in.⋅lbf)
118. INSTALL SELECTING BELL CRANK ASSY
(a) Coat the 2 bolts with sealant, install it with selecting bell
crank assy to the manual transmission case.
Sealant:
Part No. 08833–00080, THREE BOND 1344, LOCTITE
242 or equivalent
Torque: 20 N⋅m (204 kgf⋅cm, 15 ft⋅lbf)
119. INSTALL SPEEDOMETER DRIVEN HOLE COVER SUB–ASSY
(a) Install the bolt and speedometer driven hole cover sub–assy to the transmission case.
120. INSTALL CLUTCH RELEASE FORK BOOT
(a) Install the clutch release fork bolt to the manual transaxle case.
121. INSTALL RELEASE FORK SUPPORT
(a) Using a deep socket wrench, install the release fork sup-
port to the manual transaxle case.
Torque: 47.1 N⋅m (480 kgf⋅cm, 35 ft⋅lbf)