Toyota 2002 Camry - Page 735

C69653
C91168
A
B
A
C69655
C69655
C69657
–MANUAL TRANSMISSION/TRANSAXLE OUTPUT SHAFT ASSY (E351)
41–67
2197Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
18. INSPECT OUTPUT SHAFT
(a) Using V–block and a dial indicator, measure the shaft run
out.
Maximum run out: 0.03 mm (0.0012 in.)
If the run out exceeds the maximum, replace the input shaft.
(b) Using a micrometer, measure the outer diameter of the
output shaft journal surface.
Outer diameter: mm (in.)
Part Standard outer diameter minimum outer diameter
A
37.610 – 37.626
(1.4807 – 1.4813)
37.610
(1.4807)
B
34.802 – 34.512
(1.3702 – 1.3587)
34.802
(1.3702)
If the outer diameter is less than the minimum, replace the input
shaft.
19. INSPECT 2ND GEAR
(a) Using a cylinder gauge, measure the inside diameter of
the 2nd gear.
Inside diameter: mm (in.)
Standard inside diameter Maximum inside diameter
50.009 – 50.025
(1.9689 – 1.9695)
50.025
(1.9695)
If the inside diameter exceeds the maximum, replace the 2nd
gear.
20. INSPECT 1ST GEAR
(a) Using a cylinder gauge, measure the inside diameter of
the 1st gear.
Inside diameter: mm (in.)
Standard inside diameter Maximum inside diameter
51.009 – 51.025
(2.0082 – 2.0089)
51.025
(2.0089)
If the inside diameter exceeds the maximum, replace the 1st
gear.
21. INSPECT SYNCHRONIZER RING SET NO.2
(a) Coat the cone of the 2nd gear with gear oil, check that it
does not turn in the both circumference directions while
pushing it to the synchronizer ring No.2.