Toyota 2002 Camry - Page 737

C69671
C69672
C92874
SST
C69649
C69650
–MANUAL TRANSMISSION/TRANSAXLE OUTPUT SHAFT ASSY (E351)
41–69
2199Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
24. INSPECT TRANSMISSION CLUTCH HUB NO.1
(a) Check the sliding condition between the transmission
clutch hub No.1 and reverse gear.
(b) Check the tip of spline gear on the sleeve of reverse gear
for wear.
25. INSTALL REVERSE GEAR
(a) Coat the reverse gear with gear oil.
(b) Install the 3 synchromesh shifting key spring No.1 and
transmission clutch hub No.1 to the reverse gear.
NOTICE:
Do not set the reverse gear and the transmission clutch
hub No.1 in the incorrect direction.
(c) Using a screwdriver, install the synchromesh sifting key
No.1 to the reverse gear.
26. INSTALL OUTPUT SHAFT FRONT BEARING
(a) Using SST and a press, install the output shaft front bear-
ing (inner race) to the output shaft.
SST 09950–60010 (09951–00430), 09950–70010
(09951–07150)
27. INSTALL SYNCHRONIZER RING SET NO.1
(a) Coat the synchronizer ring set No.1 with gear oil, install
it to the 1st gear.
NOTICE:
Align the synchronizer ring set No.1 with the hole of 1st
gear and install.
28. INSTALL 1ST GEAR NEEDLE ROLLER BEARING
(a) Coat the 1st gear needle roller bearing with gear oil, install
it to the output shaft.