Toyota 2002 Camry - Page 752

C83568
C83562
C92888
90 100 C
C70796
Matchmarks
41–84
–MANUAL TRANSMISSION/TRANSAXLE DIFFERENTIAL CASE ASSY (E351)
2214Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
(b) Using a chisel and hammer, stake the front differential
case hole.
12. ADJUST FRONT DIFFERENTIAL SIDE GEAR
BACKLASH
(a) Hold the front differential pinion to the front differential
case side. Using a dial indicator, measure the front differ-
ential side gear backlash.
Standard backlash: 0.05 – 0.2 mm (0.0020 – 0.0079 in.)
(b) If the backlash is out of the specification, select another
front differential side gear thrust washer and adjust it.
Thrust washer: mm (in.)
Part No. Thickness Mark
41361–28230
1.00
(0.0394)
1
41361–28240
1.10
(0.0433)
2
41361–28250
1.20
(0.0472)
3
41361–28260
1.30
(0.0512)
4
13. INSTALL FRONT DIFFERENTIAL RING GEAR
(a) Using a heater, heat the front differential ring gear to 90
– 100 C (194.0 – 230.0 F).
(b) Clean the contact surface differential case.
(c) Aligning the matchmarks, quickly install the front differen-
tial ring gear to the front differential case.
Torque: 106 N⋅m (1,081 kgf⋅cm, 78 ft⋅lbf)