Toyota 2002 Camry - Page 814

C65368
C65369
–POWER STEERING VANE PUMP ASSY (2AZ–FE)
51–9
2276Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
10. REMOVE POWER STEERING SUCTION PORT UNION
(a) Remove the bolt and power steering suction port union.
(b) Remove the O–ring from the power steering suction port union.
11. REMOVE PRESSURE PORT UNION
(a) Using a socket wrench (27 mm), remove the pressure port union.
(b) Remove the O–ring from the pressure port union.
12. REMOVE FLOW CONTROL VALVE
13. REMOVE FLOW CONTROL VALVE COMPRESSION SPRING
14. REMOVE POWER STEERING OIL PRESSURE SWITCH
NOTICE:
Be careful not to drop the power steering oil pressure switch.
If the power steering oil pressure switch is dropped or strongly damaged, replace it with a new one.
15. REMOVE VANE PUMP HOUSING REAR
(a) Remove the 4 bolts and vane pump housing rear from the vane pump housing front.
(b) Remove the O–ring from the vane pump housing rear.
16. REMOVE W/PULLEY SHAFT SUB–ASSY
(a) Using a screwdriver, remove the vane pump shaft snap ring from the w/pulley shaft sub–assy.
(b) Remove the w/pulley shaft sub–assy.
17. REMOVE VANE PUMP ROTOR
(a) Remove the 10 vane pump plates.
(b) Remove the vane pump rotor.
18. REMOVE VANE PUMP CAM RING
19. REMOVE VANE PUMP SIDE PLATE FRONT
(a) Remove the vane pump side plate front from the vane
pump housing front.
(b) Remove the O–ring from the vane pump side plate front.
(c) Remove the O–ring from the vane pump housing front.