F40330
A
SST
B
Fulcrum Length
F41596
Pressure
Feed Tube
Stopper
51–14
–POWER STEERING VANE PUMP ASSY (2AZ–FE)
2281Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
38. INSTALL VANE PUMP ASSY
(a) Temporarily tighten the bolt A to the vane pump assy.
(b) Install the vane pump assy and bolt B.
Torque: 43 N⋅m (438 kgf⋅cm, 32 ft⋅lbf)
(c) Using SST and a deep socket (14 mm), tighten the bolt
A.
SST 09249–63010
Torque: 30 N⋅m (306 kgf⋅cm, 22 ft⋅lbf)
HINT:
Use a torque wrench with a fulcrum length of 345 mm
(13.58 in.).
This torque value is effective in case that SST is parallel
to a torque wrench.
(d) Connect the connector to the power steering oil pressure
switch.
39. CONNECT PRESSURE FEED TUBE ASSY
(a) Install the pressure feed tube assy and gasket to the vane
pump assy with the union bolt.
HINT:
Make sure the stopper of the pressure feed tube touches the
pump housing front as shown in the illustration.
(b) Using a spanner (27 mm) to hold the pressure port union,
torque the union bolt.
Torque: 51.5 N⋅m (525 kgf⋅cm, 38 ft⋅lbf)
40. CONNECT OIL RESERVOIR TO PUMP HOSE NO.1
(a) Connect the oil reservoir to pump hose No.1.
(b) Install the clip.
41. INSTALL FAN AND GENERATOR V BELT
(See page 14–5)
SST 09249–63010
42. INSTALL FRONT FENDER APRON SEAL RH
43. INSTALL FRONT FENDER LINER RH
44. INSTALL FRONT WHEEL RH
Torque: 103 N⋅m (1,050 kgf⋅cm, 76 ft⋅lbf)
45. BLEED POWER STEERING FLUID
46. INSPECT FLUID LEAK
To Next Page
Loading...
