I31546
I31561
(A)
(B)
I31544
(E)
(C)
(D)
55–54
–HEATER & AIR CONDITIONER COOLER COMPRESSOR ASSY (1MZ–FE)
2369Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
13. INSPECT COMPRESSOR OIL
(a) When replacing the compressor and magnetic clutch with new one, after gradually removing the refrig-
erant gas from the service valve, drain the following amount of oil from the new compressor and mag-
netic clutch before installation.
Standard:
(Oil capacity inside new compressor and magnetic clutch: 120 + 15 cc (4.1 +0.51 fl.oz.) ) – (Re-
maining oil amount in the removed compressor and magnetic clutch) = (Oil amount to be re-
moved when replacing)
NOTICE:
When checking the compressor oil level, observe the precautions on the cooler removal/instal-
lation.
Because compressor oil remains in the pipes of the vehicle, if a new compressor and magnetic
clutch is installed without removing some oil inside, the oil amount becomes too much, pre-
venting heat exchange in the refrigerant cycle and causing refrigerant failure.
If the remaining oil in the removed compressor and magnetic clutch is too small in volume,
check for oil leakage.
Be sure to use ND–OIL8 for compressor oil.
14. TEMPORARY TIGHTEN COMPRESSOR AND
MAGNETIC CLUTCH
(a) Temporarily the compressor and magnetic clutch with the
3 bolts.
15. FULLY TIGHTEN COMPRESSOR AND MAGNETIC
CLUTCH
(a) Tighten the compressor and magnetic clutch with the bolt
(A) and bolt (B).
Torque: 25 N⋅m (250 kgf⋅cm, 18 ft⋅lbf)
(b) Install the cooler compressor bracket with the 2 bolts and
nut.
Torque:
25 N⋅m (250 kgf⋅cm, 18 ft⋅lbf) (Bolt (C))
25 N⋅m (250 kgf⋅cm, 18 ft⋅lbf) (Nut (D))
18 N⋅m (184 kgf⋅cm, 13 ft⋅lbf) (Bolt (E))
To Next Page
Loading...
